Centrifugal pump Estampinox EFI is made of stainless steel, designed for pumping water and other low viscosity liquids. The pump is designed for auxiliary processes in the food, chemical, pharmaceutical, wine and other industries.
Design and characteristics
Estampinox EFI is a monoblock centrifugal pump. The pump consists of a housing made of stainless steel sheet by cold stamping, an open-type impeller made of stainless steel by cold stamping or micro-casting (depending on the pump model), a mechanical seal, a cover and a shaft. The Estampinox EFI centrifugal pump is equipped with an internal single mechanical seal.
Three-phase motor with flange B34 (B35 for motor 132), according to IEC standard, two-pole=3000/3600 rpm, with energy efficiency class according to EU directive, IP 55 protection and class F insulation.
3 фазы, 50 Hz, 230 V Δ /400 V Υ, ≤ 4 кВт
3 фазы, 50 Hz, 400 V Δ /690 V Υ, ≥ 5,5 кВт
Materials
The parts in contact with the product are stainless steel.AISI 316L steel (1.4404)
The rest of the parts are made of stainless steel.Stainless steel.AISI 304 steel (1.4301)
Gaskets in contact with the EPDM product
Mechanical seal:
The rotating part of the Cer
Stationary part C
EPDM Gaskets
Surface Treatment: Matte
Connections: ISO 7 thread
Options
The casing is made of stainless steel.AISI 304 steel.
Other materials for mechanical seals and gaskets.
Different types of connections.
Motors: other voltages, frequencies and protections.
Trolley and/or control panel.