Cable INDUCOM ARCTIC RE-Y(St)YSWAY-fl PIMF productions TKD kabel (TKD cable) It is designed to transmit data and signals in analog or digital form for measuring equipment, controllers or computer systems. It has a reinforced solid structure, has a high level of protection from interference and low attenuation. It is suitable for use in intrinsically safe installations for the 1st and 2nd explosive zone of Group II, according to IEC 60079-14 standard. It is shielded by two levels of protection: individual for each twisted pair and shared screens. And also additionally protected by solid armor made of flat or round steel wire.
It can be used not only indoors, but also outdoors (frost-resistant) and for underground laying. It is resistant to chemicals of various kinds (acids, alkalis, oils), the influence of ultraviolet rays, and is immune to moisture content in the air. The lines are carried out underground in accordance with the requirements of building codes. Several modifications are available (with up to 8 pairs of cores) using water-blocking tapes in the design.
Technical specifications of the INDUCOM ARCTIC RE-Y(St) data cableYSWAY-fl PIMF:
Number of conductive cores: up to 48;Core cross-section: up to 1.5 mm2;
Conductor: copper, 7-wire;
Configuration: Class 2, according to DIN VDE 0295 and IEC 60228;
Vein marking: for pairs, one color is black or white with numbering, for triads, three colors are used - red, black and white with numbering;
Twisting: in layers;
Insulation material: polyvinyl chloride, frost resistant;
Contact protection layer: polyester film with a thickness of 23 microns;
Screen: for each pair, an individual metal film (PiMf) with a tinned copper drainage wire, a common screen is located on top, the material is laminated aluminum film (thickness 24 microns) with a tinned copper drainage wire;
Inner shell: polyvinyl chloride, frost-resistant;
Protective shield: round or flat shaped steel wire armor (galvanized), located between PVC sheaths;
Outer shell: polyvinyl chloride, frost-resistant;
Operating voltage: 0.5kV;
Test voltage: up to 2 kV;
Conductor resistance: 12.3 - 36.7 ohms/km depending on the cross-sectional area;
Insulation resistance: minimum 100Mohm;
Capacity: up to 200 nF/km (for a cross section less than or equal to 1 mm2 up to 190 nF/km);
Minimum bending radius (stationary): 10 x Diameter;
Temperature (stationary): -60 °C /+50 °C;
Temperature (movable): -30 °C /+50 ° C;
Insulation material properties: does not contribute to the spread of fire, according to IEC 60332-1-2 and IEC 60332-3-24 (category C), IEC 60332-3-22 (Category A);
Environmental requirements: oil-resistant, resistant to aggressive chemicals (acids, alkalis, oils), UV radiation, unlimited outdoor and indoor operation.
