Inductive linear motion sensors TWK-ELEKTRONIK IWE 250 series they have a non-contact sensor system. Magnetization and signal processing are carried out by external electronic modules. Displacement sensors operate according to the principle of an inductive semi-bridge. The design of these sensors includes two symmetrical spirals for measurements, which are located in a metal cylinder made of stainless steel, which allows you to protect the structure from negative physical and chemical influences, inside this structure there is also a rod that moves longitudinally during operation. During operation, the bridge is magnetized using a 10 kHz carrier frequency generator. When the piston is displaced relative to the center, a signal appears proportional to the pulse of change during displacement. The separate electronics supplied with these sensors allow you to adjust the zero points.
You can buy inductive linear displacement sensors TWK-ELEKTRONIK IWE 250 series in our company, for the selection of equipment, please contact our specialists by phone.: saluteh or e-mail: saluteh.
Technical characteristics inductive linear motion sensors TWK-ELEKTRONIK IWE 250 series:
- Linearity: from 0.5 to 0.25 %;
- Measuring moves: from 20 to 200 mm;
- Operating temperature range: from -10° to + 80°C;
- Type of converter: 12-bit A/D;
- Protection class: IP 66;
- Interface Type: digital SSI;
- Power: 12 bits.
