Conductix crane and elevator cables-Wampfler PV

Control cable Conductix-Wampfler PV It is mainly used for signal transmission to connect an overhead control panel for crane equipment as well as for hoists (passenger and cargo), vertical suspension up to 50 meters long. Simple installation, economical offer, the structure is reinforced with steel cables on both sides, copes well with tensile loads.

It is suitable for outdoor use in fairly wide temperature ranges, resistant to aggressive factors such as humidity, ozone, ultraviolet light, ingress of oils and lubricants.

Technical characteristics of the Conductix-Wampfler PV cable:

• Number of conductive cores: 5 - 30;
• Section of the vein: 1.5 mm2;
• Diameter: 9.1 - 35.0 mm;
• Rated voltage: 0.3 - 0.5 kV;
• Conductor: electrolytic copper;
• Configuration: flexible Class 5 (IEC 60228);
• Twisting: optimized in length;
• Marking of veins: color coded according to DIN VDE 0293 part 308, over 5 wires are black with numbering, green-yellow grounding wire;
• Isolation: thermoplastic elastomer (TPE);
• The outer shell: polyvinyl chloride (PVC), 2 external steel cables are embedded, black color;
• Maximum tensile load (N/mm2): 15 (veins), 2800 (cable);
• Minimum bending radius: 5 x Cable diameter (stationary), 10 x Cable diameter (movable);
• The maximum permissible temperature for the conductor: +80 °C;
• The temperature is stationary: -40 °C ... +70 °C;
• Temperature is movable: -25 °C ... +70 °C;

Standard sizes: MTTY-O

Environmental requirements: outdoor and indoor use, resistant to UV radiation, ozone, oils, moisture, low flammability (IEC 60332-1, FT1).